Issue in POC for RA based on Progress Analysis

[misrasuman116]

Hi All,

We are planning to have the RA deriving the POC% from the Progress analysis and which we will maintain in Level 1 WBS. In the back end we have done the settings and also as detailed in the blog Results Analysis Method 7, POC Method Based On Pr... - SAP Community

The following settings are done:

Valuation Method for RA Key with the status is configured in OKG3 with progress version 100 and other settings as below:

VC maintenance as below

Assignment of CE to VC

Question : These cost elements are not existing and was copied from client 000. I hope we should assign an existing one.

SKF 30 defined for POC with usage 3

SKF is assigned to the VC.

However when I run KKA2 I am not getting the POC% which is maintained in the Progress Tab. I am new with this set up but is the POC% taken from the project builder as a part of the standard or is it taken from Progress Analysis after we run CNE1.

Regards,

Suman Misra

[misrasuman116]

I also found that after running the CNE1 only the Non aggregated POC for SKF 10 are filled from the project while the Aggregated POC for SKF 20 is not filled. Just thinking this may be one of the reason why it is also not shown in KKA2