FB03 display at 45 degrees

[davidhaynestest]

This is a strange one.

My FB03 display has started putting some fields aligned at 45 degrees;

Any ideas on how I reset it?

Thanks,

[Bohdan]

Hi david.haynestest,

I think I had this issue before, when I started using SAP GUI with Fiori theme. My solution was to deactivate this theme altogether. I did that not only because of this issue, but because Fiori-theme in GUI is not user friendly in general.

[davidhaynestest]

Thanks Bohdan, but this has not worked.

I recently upgraded to GUI release 8 and it as been fine for over a week, and just started this behaviour today.

David

[davidhaynestest]

Hello again.

I restored the default settings in the GUI and it is OK again.

David.

[Bohdan]

Hi David,

It's good that works now. As I said earlier, I'm not a fun of Fiori-theme. It is quite raw and the issue that you raised is just one example of that. What's worse, the usability is much worse. A lot of toolbars were reworked and the options which were available directly on the toolbar earlier, are now hidden somewhere deep in the menus. I forced myself to work in the new UI for 3-4 month, but could not get used to it.