cancel
Showing results for 
Search instead for 
Did you mean: 

Error CK40N

Former Member
0 Kudos

I'm running the transaction CK40N Center 1100 and says that does not exist.

He was registered in 'Determine type of Supply Special', deleted and saved the center.

CK40N ran again and keeps saying that the center does not exist in 1100, message CK598.

What can be?

Edited by: Cristiane França da Silva on Feb 22, 2011 7:53 PM

Accepted Solutions (1)

Accepted Solutions (1)

waman_shirwaicar
Active Contributor
0 Kudos

Hi,

Normally, CK598 is not caused by program error, it is caused by incorrect customizing.

Please check the note 331652. The Note should amend the text of the error message to give the material number which is causing the error in this case.

I want to supply some background to this error which should help here:

Message CK598 is not set up to include the detail of the material in question. If the plant in the special procurement is not correct then the error is justified. In this respect please check the customizing of transaction code OMD9.

Please ensure that if any plant transfers are included in the costing run that the structure explosion step is being performed as this can result in CK598 if not done.

If there are plant transfers involved here please therefore carry out the structure step explosion.

There is also another SAP note 1074574.

regards

Waman

Answers (1)

Answers (1)

Former Member
0 Kudos

hi

check whether below sap notes can help

1459041 TP: Confirmation for production lot - error message CK 598 16.02.2011

745385 BAPI: Error message CK598 in repair requests 01.07.2010

331652 Error message CK598 during cost estimate 17.05.2010

984901 Avoid evaluation of empty org-units for empty bins 28.09.2006

762088 CK11N, CK40N, costing run: Termination with message CK598 27.01.2006