Calibration Process Steps

[Former Member]

Introduction:

This scenario describes how to process the test or measurement equipment in a calibration inspection. The objective of a calibration inspection is to determine whether each piece of equipment specified in the maintenance order meets the predefined performance specifications.

Process Steps:

Step 1: Create Quality Instrument as Equipment in SAP System

Step 2: Create Catalog Code groups & corresponding codes

Step 3: Create Selected Sets

Step 4: Create Master Inspection Characteristics (MIC)

All the Qualitative & Quantitative parameters will be created as Master Inspection Characteristics in SAP system.

Step 5: Create Sampling Procedure to create the samples out of multiple equipments.

If Inspection will be done on 100 % sample, make the sampling type as 100 % Inspection.

Step 6: Create Task List for Quality Inspection.

There are different types of Task lists available. Here based on the requirement, either Equipment Task List or General Task list will be created.

Step 7: Create Maintenance Strategy to define the Calibration Frequency (Required only in case of Strategy Plan is used for Calibration)

Step 8: Create Maintenance Plan for Calibration Process

Step 9: Schedule the Maintenance Plan

Step 10: Display the Orders created based on Scheduling

Step 11: Release the order

Step 12: Results Recording for the Inspection Lot

Step 13: Usage Decision for the Inspection Lot

Step 14: Do the Completion Confirmation for PM Order operations

Step 15: Do the TECO for PM Order

[Former Member]

Hi Maheshwaran,

Thank you very much, Nice to see some good sharing.

[former_member185453]

Hi,

Very helpful post.

Thank you very much.

[Former Member]

Dear Sir,

The document is very well explained. I have a doubt regarding it. I've followed all steps, but after doing calibration, I want to re-calibrate again before entering my usage decision. How can I do that?

[Former Member]

thank you sir

[former_member403261]

Very helpful post!

[ajaysingh_daheriya]

hi,

 

Good Document , please include.

Order type - Inspection type mapping.

Inspection points while creating task list. without this inspection lot will not be created.

 

regards

ajay

[imranpathan]

can you please explain calibration through subcon. which material type should be used to do calibration through subcon.

[SharanabasanagoudaM]

Very Good information Sir,,,,