SAP CAR: Outbound to SAP DMF-based applications - what should the RFC destination be set to?

[pel2453]

Hi Community,

I have followed the steps outlined by SAP for sending sales data to DMF applications. There is this one step that says an RFC destination needs to be maintained. I do not know what the RFC destination should be.

• You have maintained the RFC destination of the receiver system by choosing Tasks Additional Details for Outbound Tasks.

The aggregation is working and the aggregate tables are populating. When I run the outbound task, it populates the staging tables. It doesn't move into the table /DMF/SALES and remains in MONITOR IMPORTS on NWBC. Please advise what the RFC destination should be to move the sales data into the DMF table.

I have searched high and low but to no avail.

Thanks.

Regards,

Paula

[arcoverde_st]

Hi Paula,

In NWBC you should be able to see some error messages for the 6 entries in error status. I would recommend first checking out those and resolve the cause. Then try processing again - the selection 'Sales Data' is sufficient.

The 76 entries should not be locked in processing. You can delete the content of the staging tables by the report '/DMF/DEL_STAGING_DATA' - but that will delete all entries. You can also manually change (no reports or standard functionality for that) the 'PSTATUS' for these entries to 'N' - so that the staging processing would pick these up again.

My recommendation would be:
1. Check the errors and address the issue
2. Try processing the entries again - hopefully those 6 entries will now be in '/DMF/TS_PS'
3. Delete the entries that are stuck in staging ('In Process' status) with the report
4. Resend the data with the Outbound task and process the staging tables again - now all 82 should be in TS_PS

Ildikó

[pel2453]

Hi Ildiko,

Thanks for the speedy response.

The errors in NWBC return no exceptions.

I ran a manual deletion on Sales Data using the Manual Deletion option in NWBC. The successful entries remain. Do you know the name of the staging table this information would be in?

The outbound task sends all the data that has been aggregated and closes the aggregate. The data cannot be resent. This is all in DEV so that's fine but there's something definitely missing. Looks like I may need to log an OSS for this as the data is aggregating in the DMF aggregate tables. It does reach the staging tables. It never leaves the staging tables though.

Thanks.

Regards,

Paula