Increasing Rows per Page

[bmursell]

Dear Experts,

We're trying to increase the rows displayed per page. The Opportunities table, for example, defaults to showing just 30 records. We would like to increase this to 100 as our users would like to see more results when using the 'Map View' variant. I found this KBA, however, when in Adapt Mode, I can't see a 'Change Properties' option which is referenced in the resolutions steps?

Any help would be appreciated.

Thank you,

Bradley

[former_member226 · Accepted solution]

Hello,

"Define Number of Rows" is only available within "Advance List Pane" section and not on OWL UI. hence you donot see the same in opportunity list view.

Furthermore, even if this is enabled for OWL UI you will not get benefited from it because at max 30 entries can be shown in a table view:

[bmursell]

Hi saurabhkabra2009

Thanks for clarifying this.

Regards

Bradley

[bmursell]

Hi Marie-José,

Thank you for your response. Strangely we're not presented with the Define Number of Rows option when triggering UI adaptation. We start the adaptation when within the Object, so perhaps we're not in the right place.

Thanks in advance,

Bradley

[mjveerhuis1]

Hi Bradly,

Adjusting the number of rows via adaption can be done in example the opportunity, quote or contact transaction itself - e.g. to in crease or decrease the number of rows = item lines i users would see. When starting the adaption the option Define Number of Rows is displayed.

In the overview pages you can select table, chunk or map view and in the adaption mode <- List, no option for adjusting the number of rows is given. Also in the map view, where batches of 30 are displayed - but in the map view i do not really care because i zoom in on my map and select transactions from my map instead of scrolling through the list displayed left from my map.

Kr.

MJ