Steps to follow when changing data length for a generated AET Field

[Former Member]

1. Identify the Enhancement ID for the AET field through WebUI Configuration.


2. Go to Table AXT_EXT_PART_DTL, Set the OBJ_PARAMVALUE parameter value to desired length by passing Enhancement ID and considering Parameter OBJ_PARAMETER as LENGTH.


3. It will not ask for any Transport Entry but include the change in a Transport Request.


4. Go to Table AXT_CAT_OBJ_DTL, set the OBJ_PARAMVALUE parameter value to desired length by passing Enhancement ID and considering Parameter OBJ_PARAMETER as LENGTH.


5. It will not ask for any Transport Entry but include the change in a Transport Request.


6. Regenerate the Enhancement ID (Tcode: AXTSHOW).


7. If after regeneration, domain length did not change in corresponding table/tables, then follow step 8.


8. Set the desired length in the Table->Data Element->Domain (SE11).


9. Activate the table. Activation gives an error in table (Expected).


10. Do a database adjustment for the required Table (SE14), in background, keeping data. It should activate the Table.


11. Again Regenerate the Enhancement ID (Tcode: AXTSHOW).


12. Once above steps are done, and then follow below 2 steps.


13. Go to AET Object in WebUI ->Display Enhancements->Enhanced Objects->Enhancement ID and check the data length is matching with the database field length.


14. Tcode: BSP_WD_CMPWB->Pass Required Component ->Corresponding View->Configuration TAB->Choose the correct configuration->select the required field -> check the data length if it is matching with Database field and AET object.