- SAP Community
- Groups
- Interest Groups
- Application Development
- Discussions
- QM view with LSMW
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
QM view with LSMW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007 Aug 24 7:27 AM
- SAP Managed Tags:
- ABAP Connectivity
Hi guys,
I am uploading QM view data with LSMW, but Inspection Setup data is not uploading, when iam recording its taking the values.... plz can any one suggest me the way... how can i go further....
thanks,
murali
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007 Aug 24 10:51 AM
- SAP Managed Tags:
- ABAP Connectivity
Hi,
I have accomplished this loading step by an LSMW recording step.
-first the Material should have QM view. else the QM view is to be opened by MM01. You can use DI program - RMDATIND in LSMW for this.
-Once the QM View is available for the material, ( MARC-PSTAT CA 'Q' ) the lines in the table control for Inspection setup could be filled by the following recording sequence:
Give the material number in the initial screen & choose the basic data 1.
<b>from the basic dat 1 view, choose the "Quality Management" tab from the Tab list which you get from selecting the tablist button ( top right button ).</b>
then push the "Insp. Setup" button & fill the data & save.
Hope this helps.
Regards, Murugesh AS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007 Aug 24 8:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007 Aug 24 10:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2007 Aug 24 10:51 AM
- SAP Managed Tags:
- ABAP Connectivity
Hi,
I have accomplished this loading step by an LSMW recording step.
-first the Material should have QM view. else the QM view is to be opened by MM01. You can use DI program - RMDATIND in LSMW for this.
-Once the QM View is available for the material, ( MARC-PSTAT CA 'Q' ) the lines in the table control for Inspection setup could be filled by the following recording sequence:
Give the material number in the initial screen & choose the basic data 1.
<b>from the basic dat 1 view, choose the "Quality Management" tab from the Tab list which you get from selecting the tablist button ( top right button ).</b>
then push the "Insp. Setup" button & fill the data & save.
Hope this helps.
Regards, Murugesh AS
