Solved: Bdc How could i click the material master view

former_member196331 · ‎2015 Nov 05

HI,

Please have a look on below attached image.

My requirement is i need to open the material code in mm02 and update the inspection type.

While recording i was open the Quality management and then i did what i need Every thing is working.

But some materials after i observed Instead of Quality management it is opening other view. General plant.

I think while recording it is recorded for 13 view. But i would like to open Quality management view.

Is there any way to Open it fixed it for Every Materials.

raymond_giuseppi · ‎2015 Nov 05

(Seems to be a 2013 copy from zevolving 2008 OP ?)

Hint: But you could (should) also consider using BAPI_MATERIAL_SAVEDATA.

Regards,

Raymond

Former Member · ‎2015 Nov 05

Hi,

Please check the following link which gives you idea:

Regards,

Surendra Gupta.

raymond_giuseppi · ‎2015 Nov 05

(Seems to be a 2013 copy from zevolving 2008 OP ?)

Hint: But you could (should) also consider using BAPI_MATERIAL_SAVEDATA.

Regards,

Raymond

former_member196331 · ‎2015 Nov 05

Hi,

Thanks for your reply.I am testing. I hope above one is giving the result correctly.

I would like to ask one question. Is it advantage of the BDC with comparing to the LSMW.

Because in LSMW also i faced the same problem. But in BDC We have a this type of Solution.

raymond_giuseppi · ‎2015 Nov 05

Don't forget that you can add some code in conversion rules of LSMW to use same type of solution.

Regards,

Raymond