2008 Dec 11 5:39 PM
Hi Chinna,
In BD64, I'm trying to create filters, but after I change from display to change mode, my Distribution Models are still grayed out, so i'm not sure If i'm being directed to the correct menu. And just to be clear I'll lay out my steps:
I double click on the "No filter set", a "display filter" menu comes up with no options on it. However when I click on "Filter Mode Display" I get some changes, I'm not sure if that's where I need to be to create my filters. Please help!
Thanks,
Samer
2008 Dec 11 8:03 PM
2008 Dec 11 8:55 PM
I'm not sure how do I create those..
Sorry for creating this here I did a search for BD64 before and all posts where in ABAP General
2008 Dec 11 8:44 PM
Those which are still greyed out were replicated from another system. You need to change them in the original system and then replicate them again.
Use the appropriate forum next time cause this has nothing to do with abap.
2008 Dec 11 8:54 PM
Hi Rainer,
Thanks a lot for the good feedback. I'll give you more explanation.
We've copied the QA DB to PRD and that proves your explanation, however the connections weren't there and I had to create them. Would they still be greyed out for that?
2008 Dec 12 9:26 AM
Goto transaction SE16N, choose table TBD00, enter the edit mode via &SAP_EDIT and change the maintenance system field to the original system and save.
After that you can edit your filter.
2008 Dec 13 10:38 PM
Hi Rainer,
Thanks for your help, i was able to click on every distanation where I changed the system to the required one. And then I was able to see the "create filter" menu.
Thanks again!
Samer
2009 Feb 19 5:24 PM
HI sameer,
Filters are two types in CDM, they are Data Filters & Segment Filters.
If you want to create Data Filters, first go in change mode after adding the Message Type to the Model View in the Below ' NO Filter Set' will be there double click on it it will open another window in that 'Create Filter group' Tab will be there click on it and Filter Group will be there then assign values to the fields and save the Model view and put that model view in a CTS.
Best Regards,
Sreekanth.
2009 Feb 19 5:44 PM