Back ground job With Event Not able to run Multiple times.

[former_member196331]

HI..

I  have created One Background job With After Event.

I am able to Trigger the Event with my Custom program. Then again with my background job Again with Custom Report with an Variant.

I am inserting the data into the Ztable. My problem is If i run the Fist time. Back ground job is Running and Saying that Job is finished In SM37

But i would like to run the Background job with multiple times. After raising the Event .  Background Jobs Status is saying Finished.
Please Have a look on below attached image. Nee Valuable suggestions.

[Former Member]

As far as I know you cannot start a job multi times. You have to create a new one. But it's of course possible to run the same program with the same parameters multi times (via different jobs).

[michael_kozlowski]

Create job under Job frequency with "Event periodic"

[former_member196331]

Thank u closing the post.

[former_member193460]

i havent understood your requirement .. But i assume you would want the job to enter multiple entries into the table.

I suggest you put that multiple entries logic inside the program and then when the program runs as a job , Multiple entries will be created as desired.

If your requirement is to have the same job running after each interval, then you can set the job as a periodic job.

[Juwin]

As mentioned by , you missed a checkbox while mentioning the scheduling parameters.

Please check that, and it will trigger repetitively.

Thanks.

[former_member196331]

Ok i will check it.

[Former Member]

Hi,

See below link

Periodic Scheduling of sequencial background job | SCN