Question Re: SLT system cleanup in Technology Q&A

SLT system cleanup

Former Member — Fri, 20 Jun 2014 15:59:51 GMT

Hi,

We are replicating data from CRM to SAP HANA using SLT.

We done a lot of development on SLT (created a lot of configurations, deleted them, then recreated them again, e.t.c).

But as SLT is not deleting all objects compleatly we have a real mess now in system. For instance we have only 5 configurations working now in system, but we have already used number 155 of mass transfer. Because of that we are expiriencing some other issues.

Is there some wise way to do system clean-up?

Thanks in advance,

Markus

Re: SLT system cleanup

tobias_koebler — Mon, 23 Jun 2014 07:27:23 GMT

HI markus,

MT id's will not be cleaned up, this how it was designed.

Best,
Tobias

Re: SLT system cleanup

Former Member — Wed, 02 Jul 2014 05:48:28 GMT

Hi Tobias,

It is disappointing to hear that, our system will become more and more messy...

BR,

Markus

Re: SLT system cleanup

tobias_koebler — Wed, 02 Jul 2014 07:23:30 GMT

Hi,

sorry, but I do not think the system get messy if a single number (that acts as an ID) will increase and not resetted.

Best,

Tobias

Re: SLT system cleanup

Former Member — Mon, 10 Nov 2014 21:11:39 GMT

Hi Markus,

There are few IUUC* tables which hold the information of the MTDs..

So you need to remove the table entries from these below 3 tables only to get rid of the old SLT Configuration.This has to be done before you create a new fresh LTRC Configuration..

IUUC_REPL_CONFIG
IUUC_REPL_CONpar
IUUC_REPL_map

Note: This is a bit risky thing to perform as you have to use the debugger screen in SE16 & delete the entries for these tables..

Regards,

Joydeep.