Question Re: Issues in Adapting Java system properties in Technology Q&A

Issues in Adapting Java system properties

Former Member — Thu, 13 Jun 2013 14:18:17 GMT

Hello SAP PI Gurus,

We are having a Sync SOAP to RFC scenario.

Whenever the muser is sending message and the processing time gets more than 180 seconds, then the 500 internal server issue is coming.

On checking in SDN , we found some recommended solution as follows :

In NWA, Go to->Operation Management->Systems-> Start & Stop -> Java Services -> (Under Related Tasks) Java System Properties.

Increase the value of the timeout parameter 'xiadapter.inbound.timeout.default' under Services -> 'XPI Adapter:XI'

to a higher value say '600000'.

In my attached screens hot i am stuck and not able to proceed ahead as i am not able to find

parameter 'xiadapter.inbound.timeout.default' anywhere on the page .

Can someone help me ?

Regards,

Ravi

Re: Issues in Adapting Java system properties

Former Member — Thu, 13 Jun 2013 14:31:21 GMT

Hi Ravi,

You have to increase the timeout value for RFC adapter, by default it waits 3 minutes to get resoinse back from ECC after that it throws error.

Personally i dont recommend to increase this value, is you sender system can wait more then 3 minutes to get resoponse from PI?

Thank you,

Raj

Re: Issues in Adapting Java system properties

Former Member — Thu, 13 Jun 2013 14:38:45 GMT

Hi Ravi,

your information at least not complete. Increasing the timeout for synchronous scenarios is much more complex because several appliations are involved: sender system, receiver system, PI adapter (in your case RFC and SOAP), PI integration engine (double stack) or AAE.

You should consider alternatives, because general timeout enhancements can reduce the system performance.

How to Investigate Timeouts In Synchronous XI PI Scenarios

/Udo

Re: Issues in Adapting Java system properties

Former Member — Thu, 13 Jun 2013 18:42:07 GMT

Hello Raja,

How can you increase the time out value of the RFC Adapter !!

Can you please let me know !!

Thank you,

Ravi.

Re: Issues in Adapting Java system properties

marksmyth — Fri, 14 Jun 2013 08:14:57 GMT

Hello,

The parameter you mention is located in http://<server>:<port>/nwa/sys-config -> Services -> XPI Adapter: XI.

Regards

Mark