Question Re: While confirming a Transfer order in LT12 i get the f... in Enterprise Resource Planning Q&A

While confirming a Transfer order in LT12 i get the following error stating that only 3 quantity of

Abhi_2345 — Fri, 16 May 2025 15:31:49 GMT

However in MMBE the unrestricted stock is 13pcs ... where do we check if the quantity is blocked

Re: While confirming a Transfer order in LT12 i get the f...

Dominik_Tylczynski — Mon, 19 May 2025 06:33:20 GMT

The message says that only 3 ST of the material are available according to ATP logic. ATP can be checked with CO09. MMBE shows stock levels, but not ATP quantities!

ATP check at the time of transfer order confirmation / picking results reporting can be switched off in the delivery item category configuration:

Also see the note 1653018 - Error VL198 raised during TO confirmation

Best regards

Dominik Tylczynski

Re: While confirming a Transfer order in LT12 i get the f...

Abhi_2345 — Tue, 10 Jun 2025 15:58:18 GMT

Hi Dominik ,

After implementing the now this error doesnt occur that frequent , but however it comes up now and then ,yesterday as well when the user was confirming the transfer order he was getting an Error that there is 0 quantity of the given material.

However there 1 pc quantiity available in the storage area.

Anything else that can be checked ....