topic Semaphore could not be set while doing client copy in DevOps and System Administration Forum

Semaphore could not be set while doing client copy

former_member700385 — Thu, 23 Jul 2020 10:38:44 GMT

Hello,

I am trying to do a client copy in a system(S4/HANA 1909 FPS01) and getting the error message "semaphore could not be set - subrc:9. The client copy job runs only for 5 seconds. Has anyone encounterd this before.

The same is the case if I try to delete a client

Screen shot attached

.sccln-error.jpg

Heinz

Re: Semaphore could not be set while doing client copy

alichtenau — Thu, 23 Jul 2020 11:22:41 GMT

Hi Heinz!

Maybe there is a leftover in table LMSEMAPHORE similar to the issue explained in SAP Note 2705038 (SCCL local client copy gives error : "Could not lock source client"). This can be caused (for example) by a cancelled copy.

Please try to delete this semaphore using DB tools or SE16.

Cheers,
Andreas

Re: Semaphore could not be set while doing client copy

former_member700385 — Thu, 23 Jul 2020 14:20:41 GMT

Thank you Andreas,

You were right to the point. There was a left over from an add on installation where in the final Finish was missing. I did a finish of the same and the entry in the LMSEMAPHORE table got cleared by itself.

After that i could successfully delete the client and start another client copy. It is running fine now.

Thank you so much..

Heinz