topic Re: Mach Code in Application Development and Automation Discussions

Mach Code

Former Member — Tue, 22 Jul 2008 15:58:46 GMT

Hi,

Is there any MATCHCODE for the following fields.

1.Document Type (BLART)

2. G/L Account(HKONT)

3.Cost Center(KOSTL)

Pls help me.

Thanks.

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:01:47 GMT

Dont Duplicate the Threads.

Please check the search helps.

BLART->SHLP_ISCD_BLART

HKONT->FKK_HKONT

KOSTL->TRAC_KOSTL

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:02:36 GMT

Hi,

What's wrong with the answer you've already been given?

Regards,

Nick

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:05:28 GMT

also you can make your own matchcode....check this.

AT SELECTION-SCREEN.

  IF p_kostlv IS INITIAL AND
     p_kostl IS INITIAL AND
     p_plans IS INITIAL.

    MESSAGE e001(00) WITH 'Debe ingresar al menos un valor'.
  ENDIF.

AT SELECTION-SCREEN ON value-request for p_plans-low.

  SELECT *
  INTO CORRESPONDING FIELDS OF TABLE t_match
  FROM pa0001
  where plans between '50000000' and '59999999'.

  LOOP AT t_match.

    SELECT SINGLE plstx
      INTO t_match-plstx
      FROM t528t
      WHERE plans EQ t_match-plans
          AND sprsl EQ 'S'.
    MODIFY t_match.

  ENDLOOP.


  CALL FUNCTION 'F4IF_INT_TABLE_VALUE_REQUEST'
    EXPORTING
      retfield    = 'pernr'
      dynprofield = 'p_pernr'
      dynpprog    = sy-repid
      dynpnr      = sy-dynnr
      value_org   = 'S'
    TABLES
      value_tab   = t_match.

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:06:19 GMT

That anwer was wrong.

These match codes does not exists

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:09:13 GMT

Hi,

Then reply to the original thread, don't just post a new one.

Just out of curiosity, why are you wanting to use a matchcode rather than a search help?

Regards,

Nick

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:11:41 GMT

Hi,

When I am giving these match code. My screen lay out is not taking these values.

Re: Mach Code

Former Member — Tue, 22 Jul 2008 16:24:27 GMT

show how are you doing the coding if possible.