topic Re: Transaction Code Problem in Application Development and Automation Discussions

Transaction Code Problem

Former Member — Fri, 16 Dec 2005 19:41:14 GMT

Hi all,

I created a transaction code and assigned it to a program, when i tried to run the transaction, it loads everything up, it shows the selection screen, etc. but when you press the execute button, it goes right back to the SAP menu and would not run. Any advice?

Oh, I forgot to mention that when the program is run using SE38 and not through the transaction code, it does not have problem.

Thanks,

Ricky

Message was edited by: Ricky Orea

Re: Transaction Code Problem

Former Member — Fri, 16 Dec 2005 19:45:36 GMT

Hi,

I think while creating the T code you selected a wrong radio button for program assignment.If it is a report program you need to check 2nd radio button (Program and selection screen) or if it a dialog program check the first one.

Hope this helps..

Vijay.

Re: Transaction Code Problem

Former Member — Fri, 16 Dec 2005 19:45:38 GMT

When you create the transaction, select the second ratio button 'Program and selection screen (report transaction)'.

It should work.

Good luck.

Please close the issue with appropriate points if it helps.

Venu

Re: Transaction Code Problem

Former Member — Fri, 16 Dec 2005 19:55:55 GMT

Hi Ricky,

While creating the Transaction select the radio button

report transaction.

then you will be able to run,..

regards

vijay

Re: Transaction Code Problem

Former Member — Sat, 17 Dec 2005 09:07:25 GMT

u should click the second check box thats for reports .

Also check the package u mentioned leave it blank it will show $tmp default. Do give any thing in the application type parameter unless u know ur appln type and have authorization.

regards

vijay

Re: Transaction Code Problem

Former Member — Mon, 19 Dec 2005 14:44:28 GMT

Friendly reminder:

Please close the issue with appropriate points if the problem is solved.

Venu