topic PRINT_TEXT IN ECC6.0 in Application Development and Automation Discussions

PRINT_TEXT IN ECC6.0

Former Member — Mon, 21 Jul 2008 11:43:43 GMT

Hi,

We are using the FM PRINT_TEXT to send fax. But the fax sending is failing. No entries were found in SOST transaction after executing the program to send the fax. Fax numbers are maintained in SXROUTE table. Prior to upgrading to 6.0, the program was sending fax in 4.6c.

Any inputs will be of great help.

Thanks,

Sita.

Re: PRINT_TEXT IN ECC6.0

Former Member — Mon, 21 Jul 2008 11:48:16 GMT

Check the SCOT settings for Fax.

May be they are changed. Reset the settings and try again.

Re: PRINT_TEXT IN ECC6.0

Former Member — Mon, 21 Jul 2008 11:57:10 GMT

One more point to add - the spool is also not getting created.

I have checked the SCOT settings and tested using Utilities --> Routing test too.

3 steps as below were shown without any errors.

1. Check entered addresses

2. Determine node

3. Convert address into an external format

Explanation on pressing F3 from the above screen:

SAPconnect: Explanation of Routing and Address Conversion 1

The following node is used to determine the dialling code: FCLINK

The following destination country is used to determine the dialling code: US

This results in a domestic call in country US

Number of possible entries for "Node exceptions": 0

Edited by: Sita Mahalakshmi V Gurram on Jul 21, 2008 2:31 PM