topic Re: Selection Screen in Application Development and Automation Discussions

Selection Screen

Former Member — Fri, 11 Jul 2008 11:27:54 GMT

Hi Friends,

I want to create a selection screen with two radio buttons and on selecting a particular radio button, a screen within the main selection screen should display with the corresponding values.

Kindly guide me to do this.

TIA.

Regards,

Mark K

Re: Selection Screen

Former Member — Fri, 11 Jul 2008 11:29:55 GMT

Hi,

in At selection-screen on radiobutton group g1.

Write the Logic.

PARAMETERS :p_rad1 RADIOBUTTON GROUP rad1, default 'X' user-command rad1

p_rad2 RADIOBUTTON GROUP rad1 .

AT SELECTION-SCREEN ON RADIOBUTTON GROUP RAD1.

if p_rad1 = 'X".

CALL SCREEN 1100.

Elseif p_rad2 = 'X'.

Call Screen 1200.

Endif.

Regards,

Sujit

Re: Selection Screen

Former Member — Fri, 11 Jul 2008 11:32:35 GMT

use event AT SELECTION-SCREEN OUTPUT.

write your code in it

if radiobutton = 'X'.

loop on screen and assign values to the fields as you wish

they will get displayed on screen

endif.

give points if it works.

regards,

rajyalaxmi

Re: Selection Screen

Former Member — Fri, 11 Jul 2008 11:32:37 GMT

hi,

Create your selection screen with the two radiobuttons and

a frame in invisible mode on the same screen.

On clicking on the radio button write the code to show the frme and Assign the value in

AT SELECTION-SCREEN OUTPUT event.

Hope this will help.

Sumit Agarwal