topic Re: BDC in Application Development and Automation Discussions

BDC

Former Member — Tue, 17 Jun 2008 03:48:28 GMT

Hi,

I am trying to run a BDC on a PA40 action. The trouble is when in the session, when a new pop up widow is called for adding entries...and then again when i move back to the original screen, the data is NOt being populated in the original screen.

Any reason;'s for this?

I could see that the Internal table before the BDc session is called is correctly populated.

Kindly Advice.

-Anand

Re: BDC

Former Member — Tue, 17 Jun 2008 04:16:20 GMT

Hi,

I think this may be due to the change in order of passing the ok codes.

please try the same scenario using the SHDB recording. then create a program from the recording and then compare the order in which the ok codes are passed.

this solves your problem.

Thanks and regards

Re: BDC

Former Member — Tue, 17 Jun 2008 04:18:31 GMT

Hi.

Yes,please do the recording from SHDB and generate a program then pass on the internal table fields to the performs, I am sure this will solve the problem.

Thanks and Regards,

Vishwa.