topic BAPI BAPI_SALESORDER_CREATEFROMDAT2 in Application Development and Automation Discussions

BAPI BAPI_SALESORDER_CREATEFROMDAT2

Former Member — Thu, 17 Nov 2005 15:48:22 GMT

Hi all,

I create sales orders using the bapi BAPI_SALESORDER_CREATEFROMDAT2. Does anyone know how to enter manually the tax amount (not the percentage) in the condition MWST? In fact I want to enter my own tax amount independent of the tax percentage.

Regards

Re: BAPI BAPI_SALESORDER_CREATEFROMDAT2

Former Member — Thu, 17 Nov 2005 18:28:29 GMT

George,

Documentation for this BAPI clearly specifies how to enter the condition value. If you want a percentage enter percentage in condition value and do not populate currency or Currency_iso fields. If you want to pass a value then enter the value in condition value and populate currency or currency_iso fields.

Here is the documentation of the BAPI for Condition input

Conditions

Description

This parameter contains condition data

Value Range

When you complete the COND_VALUE and CURRENCY fields, you must decide which of the following applies:

The condition calculation type is expressed in percentage (the T685A-KRECH field contains AHI)

In this case you should leave the CURRENCY field blank and enter the percentage value with a comma

Example:

Enter percentage rate 20% as 20,0000 in the COND_VALUE field.

The condition calculation type is not expressed in percentage

In this case the COND_VALUE field is a currency quantity field. You must enter the CURRENCY or CURRENCY_ISO field so that the correct conversion takes place. Again, you must enter the amount kommagerecht.

If neither the CURRENCY or the CURRENCY_ISO fields are completed, the entry is issued as a percentage value. This could lead to an incomplete entry if the condition type is not in percentages.

Thanks

Giridhar

Re: BAPI BAPI_SALESORDER_CREATEFROMDAT2

Former Member — Fri, 18 Nov 2005 06:52:08 GMT

Dear Giridhar,

Your answer was very helpful to my understanding of the function of the specific bapi.

Regargs

George

Re: BAPI BAPI_SALESORDER_CREATEFROMDAT2

simon_broome — Fri, 12 Dec 2008 15:41:45 GMT

I am trying to acheive the same result as asked in the original question and have acted as advised. Generally MWST cannot be processed manually - what route did you take to acheive your objective?

Thanks