topic Re: ASAP:Debugging in Application Development and Automation Discussions

ASAP:Debugging

Former Member — Fri, 13 Jun 2008 06:55:29 GMT

Have written some coding in the user exit how to debug it?

Former Member — Fri, 13 Jun 2008 06:56:50 GMT

Put a break point in your exit.

Run the transaction that will trigger your exit.

Thanks,

Victor.

Former Member — Fri, 13 Jun 2008 06:56:55 GMT

go into the code and write break-point in it.

Former Member — Fri, 13 Jun 2008 06:57:43 GMT

Hi,

Place a static break-point in that exit.Then run the transaction.It will start the debugger when the exit gets fired.

Former Member — Fri, 13 Jun 2008 06:59:43 GMT

Hi Saranya,

Never ever use break-point in general, always be specific when you want to debug a exit. Use the following syntax :

BREAK <USERID>

Hope this is helpful to you. If you need further information, revert back.

Reward all the helpful answers.

Regards

Nagaraj T

Former Member — Fri, 13 Jun 2008 07:03:50 GMT

Hi,

write static breakpoint using BREAK USERID avoid using BREAK-POINT that might cause some problems.

Then execute ur transaction.

Rgds.,

subash

Former Member — Fri, 13 Jun 2008 07:28:28 GMT

Write BREAK USERID or BREAK-POINT at the first line of the include program.

Former Member — Fri, 13 Jun 2008 07:32:16 GMT

saranya srithar,

Write STOP where you want to debug.

than run the t-code it will trigger and stop at here.

Amit.

Former Member — Fri, 13 Jun 2008 07:47:25 GMT

check this link