call transaction

Former Member — Tue, 10 Jun 2008 11:37:40 GMT

hello,

iam doing bdc with call trnsaction.

in call transaction display error message for a mrp value in transaction and continue with another value.

in bdc for transaction iam passing multiple mrp controllers .

for each nad every value it should perform call transaction

display error message and continue with another value .

iam getting system error message and stoping not continuing with another value.

Re: call transaction

Former Member — Tue, 10 Jun 2008 11:40:53 GMT

Hi,

Check this

CALL TRANSACTION tcod ... MODE mode

The specified processing mode can accept the following values:

'A' Display screen

'E' Display screen only if an error occurs

'N' No display

If the addition MODE is not specified, the processing mode is set to 'A' .

The MODE Parameter

You can use the MODE parameter to specify whether data transfer processing should be displayed as it happens. You can choose between three modes:

A Display all. All screens and the data that goes in them appear when you run your program.

N No display. All screens are processed invisibly, regardless of whether there are errors or not. Control returns to your program as soon as transaction processing is finished.

E Display errors only. The transaction goes into display mode as soon as an error in one of the screens is detected. You can then correct the error.

topic call transaction in Application Development and Automation Discussions

call transaction

Re: call transaction