topic Re: Debug Call transaction in N mode in Application Development and Automation Discussions

Debug Call transaction in N mode

Former Member — Thu, 19 Jun 2008 13:10:36 GMT

Hi,

How to debug BDC call transaction program with mode N.

Regards,

Rams

Re: Debug Call transaction in N mode

Former Member — Fri, 20 Jun 2008 05:20:09 GMT

Hi,

Keep a break-point in the program or before executing the program, enter /h in the command field and then execute the program.

M S DhanaLakshmi

Re: Debug Call transaction in N mode

nikhil_chitre — Fri, 20 Jun 2008 05:25:45 GMT

Put an Break Point at call transaction...

And change the mode from 'N' To A.

Regards,

Nikhil

Re: Debug Call transaction in N mode

Former Member — Fri, 20 Jun 2008 05:30:37 GMT

hi,

You can directly put a break point in the BDC program.

But there is a restriction that if you put any breakpoints in any of the transactions in N mode it goes to dump instead of N mode go to P mode.

N : Processing without display of screens. If a breakpoint is reached in one of the called transactions, processing is terminated with sy-subrc same as 1001. The field sy-msgty contains "S", sy-msgid contains "00", sy-msgno contains "344", sy-msgv1 contains "SAPMSSY3", and sy-msgv2 contains "0131".

P Processing without display of the screens. If a breakpoint is reached in one of the called transactions, the system branches to the ABAP Debugger.

Reward points if helpful.

Thanks and regards.

Re: Debug Call transaction in N mode

former_member195383 — Fri, 20 Jun 2008 05:32:31 GMT

Hi...

Just change the type from N to A or E then when u arive at the screen put /h and then debugg.

After ur debugging is done..then u can again change the mode from A or E to N

Re: Debug Call transaction in N mode

Former Member — Thu, 19 Sep 2013 16:35:26 GMT

hi,

i have a similar kind of issue. i have a bdc for PA40 using call transaction. it is sometimes uploading the complete data sometimes few fields are missing. When fields are missing,that time bdc breaks without any error.

what could be the possible reason o the data not getting populated.

need a solution urgently.

thanks,

shobhika