topic Re: BSP Application - Looking For A Parameter in Application Development and Automation Discussions

BSP Application - Looking For A Parameter

Former Member — Mon, 23 Jun 2008 16:01:51 GMT

Hello,

I have the following (rather annoying) problem:

We are working with a BSP-Application in which directly in the Beginning (in the "OnCreate"-Method of the entry page) an SAP Memory Parameter is read through a "GET PARAMETER" Statement. The Problem is: Where is it set?

Is there a defined place where such parameters are stored? Or how is this handled normally? After searching the whole BSP-Code there was no "SET PARAMETER" call anywhere, so we have to assume that this happens somewhere outside the BSP-App. Perhaps it's hardcoded somewhere??

Does any of you have an idea, how I should go about this problem?

Thanks in advance,

Lukas

Re: BSP Application - Looking For A Parameter

Former Member — Mon, 23 Jun 2008 18:14:15 GMT

Hi check if parameter is specified as part of the URL using the delimiters ? and &.

Re: BSP Application - Looking For A Parameter

Former Member — Tue, 24 Jun 2008 07:32:03 GMT

Yes, good idea. But I checked and the URLs are exactly the same for all users.

Re: BSP Application - Looking For A Parameter

Former Member — Tue, 24 Jun 2008 07:35:02 GMT

it is from the URL thats for sure.

can you explain the flow..

May be you are looking for the Main Url. but there is a chance that you might get some url in the middle of the flow. there they might be adding the param. Just check for the

?paramname

in the whole bsp application.

Re: BSP Application - Looking For A Parameter

Former Member — Tue, 24 Jun 2008 09:08:04 GMT

Well the parameter im looking for changes depending on the user that is currently logged in. so it can't be in the urls I think.

This is the snippet of code that checks the parameter:

DATA: lv_parameter(2) TYPE c.
GET PARAMETER ID '/BIC/OMSGLVARPO' FIELD lv_parameter.

its almost at beginning of the bsp app flow.

Re: BSP Application - Looking For A Parameter

Former Member — Tue, 24 Jun 2008 12:51:20 GMT

Everyone, thank you for your replies, but we've been able to solve the problem differently. The Parameters were implicitely set with the user data, in the table

USR05

to be exact.