topic Re: CHECK statement in Application Development and Automation Discussions

CHECK statement

Former Member — Thu, 29 May 2008 10:54:22 GMT

hi all,

i have a code where i have used CHECK statement within LOOP...ENDLOOP.

the statement is as follows:

CHECK wa_rseg-ebeln IN s_ebeln

but even though this condition is false its going to the next statemtn and executing it without skipping that LOOP pass...

how is it posssible?

please give me the solution....

Re: CHECK statement

Former Member — Thu, 29 May 2008 10:57:10 GMT

Hi,

Use like below..

IF wa_rseg-ebeln IN s_ebeln

ELSE.

continue.

ENDIF.

Rgds,

Bujji

Re: CHECK statement

former_member435013 — Thu, 29 May 2008 12:13:51 GMT

Hi,

I don't believe that.

Have an intensive look at your check condition: length of fields, leading zeroes, alignment etc. .

regards

Walter Habich

Re: CHECK statement

Former Member — Thu, 29 May 2008 12:16:07 GMT

Hi,

Here Is the Sample Program Using Check statement Hope this Might Help you.

REPORT demo_program_check_1.

NODES: spfli, sflight, sbook.

START-OF-SELECTION.

LOOP AT airp_fr.

CHECK airp_fr-low NE ' '.

WRITE: / 'Selected Aiport-From:', airp_fr-low.

ULINE.

ENDLOOP.

LOOP AT airp_fr.

CHECK airp_to-low NE ' '.

WRITE: / 'Selected Airport-To:', airp_to-low.

ULINE.

ENDLOOP.

GET sflight.

WRITE: / 'Connid:', sflight-connid,

'Carrid:', sflight-carrid,

'Fldate:', sflight-fldate.

Reward If helpfull,

Naresh.

Re: CHECK statement

Former Member — Thu, 29 May 2008 12:17:22 GMT

Good chance s_ebeln contains no values. If that is the case, anything is valid and will pass through