topic Re: selection screen in Application Development and Automation Discussions

selection screen

Former Member — Fri, 09 May 2008 04:36:50 GMT

I have a parameter on my selection screen.

I enter a value for the parameter and excecute it.

Now when i return from the output to the execution screen.

There should not be any value on the screen.

Thanks and Regards,

Re: selection screen

prasanth_kasturi — Fri, 09 May 2008 04:40:19 GMT

do the following way,

i implemented for select-options you do for parameters..

at selection-screen .

if sy-ucomm = 'ONLI'. " Only when execute is pressed

v_low = s_kunnr-low.

v_high = s_kunnr-high . " Hang on to this for select statement

clear s_kunnr[].

clear s_kunnr. " Clear the screen parameter

endif.

start-of-selection.

slecting data for basic list(kna1)

SELECT kunnr name1 land1

FROM kna1

INTO TABLE it_kna1

WHERE kunnr between v_low and v_high.

modify according to your prog

reward if helpful

prasanth

Re: selection screen

Former Member — Fri, 09 May 2008 04:42:51 GMT

Use clear statement in INITIALIZATION screen.

or in end-of-selection.

Regards.

Madan.

Re: selection screen

Former Member — Fri, 09 May 2008 04:42:59 GMT

In the At Selection Screen Output event clear the all the values of the parameters.

ex:

At Selection Screen Output.

Clear: p_matnr, p_lifnr.

Re: selection screen

Barada_Swain — Fri, 09 May 2008 04:44:12 GMT

Hi Somay,

Use the event AT SELECTION-SCREEN OUTPUT to clear the parameter value. It gets triggered just before the screen display.

Thanks

Barada

Edited by: Baradakanta Swain on May 9, 2008 6:44 AM

Re: selection screen

Former Member — Fri, 09 May 2008 06:24:59 GMT

hi,

u can go for clearing the parameter in the selection screen output.

CODE:

at selection-screen output.

clear p_tcode.

hope this helps.

Thanks & Regards,

Ramya

Re: selection screen

Former Member — Fri, 09 May 2008 06:45:11 GMT

use clear in the INITIALISATION.

reward iff helpful.