topic internal table query in Application Development and Automation Discussions

internal table query

former_member530652 — Mon, 12 May 2008 04:55:20 GMT

data: begin of itab occurs 0,

gdatu1(10) type c,

end of itab.

DATA: BEGIN OF ITAB2 OCCURS 0,

GDATU1(10) TYPE C,

END OF ITAB2.

there are more than one line items in itab...i want to trnsfer

data from itab2 to itab....

i tried this one:

LOOP AT ITAB2.

MOVE-CORRESPONDING ITAB2 TO ITAB.

modify itab." transporting gdatu1.

ENDLOOP.

but it shows run time error at the endloop statement....when i use modify itab transporting gdatu1.

it shows runtime error on this line..

any solution....

Re: internal table query

Former Member — Mon, 12 May 2008 05:03:40 GMT

Hi Sandeep,

Whenever if you use Move-Corresponding see that the structure in both the internal tables are same(in your case ITAB and ITAB2). Instead move the single field as per your requirement(move itab2-xxxx to itab-xxxx).

Regards,

Naresh

*Please Reward points if found useful

Re: internal table query

Former Member — Mon, 12 May 2008 05:05:10 GMT

hi,

use index while using modify.

Loop AT itab.

Read itab1 ..with key.. field = itab-field.

v_index = sy-tabix.

Modify itab index v_index from itab-field

ENDLOOP.

please reward if helpful .

Re: internal table query

amit_khare — Mon, 12 May 2008 05:05:54 GMT

Change it like this -

LOOP AT ITAB2.] into wa_itab2.

modify itab from wa_itab2 transporting gdatu1. (Check Syntax for Modify)

ENDLOOP.

Re: internal table query

Former Member — Mon, 12 May 2008 05:06:45 GMT

Hi,

try as follows

loop at itab2.

move itab2-gdatu1 to itab-gdatu1.

endloop.

Regards,

kk.

Re: internal table query

anub — Mon, 12 May 2008 05:33:12 GMT

hi,

As far as i understood ur query, your table ITAB2 has only one field which you want to update in table ITAB. But do you have any primary or common field in both ur tables?? Or is it that you require whatever data there is in itab2 to ur itab... if that is the case y do u need to fill the data in itab2 table because there is no one to one correspondence in both the tables. it would be better that you take the gdatu as a variable and not in a table. then you can loop at table itab and modify its records with the gdatu field. for eg

data : sgdatu like ....-gdatu.

loop at itab .

itab-gdatu = sgdatu.

modify itab index sy-index.

endloop.

Try this.

Hope it is helpful to you.

Reward if useful.

Regards,

Anu,