topic Re: User Exit in Application Development and Automation Discussions

User Exit

Former Member — Wed, 16 Nov 2005 23:55:03 GMT

Hi,

In the prg. SAPMF02K I am writing my code inside user exit EXIT_SAPMF02K_001 under Include ZXF05U01...

My requirement is that I have to change the name1 feild for an existing vendor. So my user exit code should trigger only when XK02 tcode is used and only for existing vendors... How do I capture the Tcode which is given on the command line?? and how do I check if the vendor is existing or not??

Please help.

Thank You,

-SB.

Re: User Exit

suresh_datti — Wed, 16 Nov 2005 23:56:19 GMT

Tcode is available in the system field SY-TCODE

Suresh

Re: User Exit

Former Member — Wed, 16 Nov 2005 23:56:59 GMT

Just use if SY-TCODE = 'XK02'.

Re: User Exit

Former Member — Thu, 17 Nov 2005 00:00:28 GMT

And how do I check for existing vendors??

Re: User Exit

suresh_datti — Thu, 17 Nov 2005 01:06:40 GMT

Pl try this...

IF SY-TCODE = 'XK02'.

select single * from lfa1 where lifnr = i_lfa1-lifnr.

if sy-subrc eq 0.

i_lfa1-name1 = new_name.

endif.

ENDIF.

Good Luck,

Suresh Datti