topic Re: Example of Module pool in Application Development and Automation Discussions

Example of Module pool

Former Member — Tue, 13 May 2008 07:51:32 GMT

Hi all,

I m new to module pool.

I have seen steps of module pool in sdn.

Go to se80 and give some program name, (in attributs select type as MODULE POOL) it creates all PAI n PBO modules automatically.

Here i m not getting on the screen , where to write program name , where to set the attributes.

Plz tell me in detail all the steps of it.

Best Regards,

Aastha

Re: Example of Module pool

Former Member — Tue, 13 May 2008 07:58:42 GMT

check this link

http://www.saptechnical.com/Tutorials/ABAP/Checkbox/page1.htm

Re: Example of Module pool

Former Member — Tue, 13 May 2008 09:16:51 GMT

Hello Jyothsna,

Thaks 4 ur reply, It is a good link, but i stuck up in b/w . Can u help me out, In this link, after 6th snap shot , they assign attributes 4 each field, where 2 go 4 attributes

Best Regards,

Aastha

Re: Example of Module pool

Former Member — Tue, 13 May 2008 09:26:30 GMT

Hi,

You just double click on the input field you will getscreen painter screen. Over their under name assign the attribute .

In the case of check boxes double click on the boxes again you will get the screen painter again assign the attribute over their.

Reward some points.

Bye,

Anomitro

Re: Example of Module pool

Former Member — Tue, 13 May 2008 09:42:02 GMT

Hi dear

www.sapbrain.com

here you have each and every snapshot go through it and proceed