topic Re: Program runs with se38 but not with transaction code in Application Development and Automation Discussions

Program runs with se38 but not with transaction code

Former Member — Thu, 08 May 2008 10:47:46 GMT

Hi Experts

I have developed a program that runs successfully in se38, I have created a transaction for it, and after entering data on the selection screen, the program just stops and returns to the 'SAP Easy Access' screen.

I have looked at this in debug mode when calling the transaction, the program gets as far as START_OF_SELECTION then just drops out back to the in initial 'SAP Easy Access' screen.

Does anybody have any ideas?

Thanks in advance

David

Re: Program runs with se38 but not with transaction code

former_member188827 — Thu, 08 May 2008 10:52:54 GMT

how have you created the transaction code?when u specify tcode in se93 and click on create which option did u choose?

it should b program and selection screen(report transaction) i.e. second option

Re: Program runs with se38 but not with transaction code

b_deterd2 — Thu, 08 May 2008 10:53:03 GMT

Hi,

Check your tcode with SE93 (there is a check button).

Is it consistent ?

regards,

bert

Re: Program runs with se38 but not with transaction code

Former Member — Thu, 08 May 2008 10:58:48 GMT

Hi,

It seems while creating the transaction code you should have selected the radiobutton pertaining to the 'Program & Selection Screen ( i.e. Rport transaction ), but by mistake you have clicked some other radiobutton. Create another transaction by selecting the Report transaction' as mentioned above & test it out.

I hope this helps,

Regards

Raju Chitale

Re: Program runs with se38 but not with transaction code

Former Member — Thu, 08 May 2008 12:02:24 GMT

Thanks Raju

That sorted it, I had used the wrong type when creating the transaction originally