topic Re: sELECT-OPTIONS TROUBLE in Application Development and Automation Discussions

sELECT-OPTIONS TROUBLE

Former Member — Fri, 25 Apr 2008 17:59:42 GMT

I have two t-codes

z_a and a_b

and a select-options field , if z_a is run the selection options must be no-intervals , no extension. and be normal when z_b is run , is this possible in

"at selection-screen output" .

THanks

Re: sELECT-OPTIONS TROUBLE

Former Member — Fri, 25 Apr 2008 18:11:40 GMT

Hello,

You can do the following:


TYPES:
  ty_r_carrid TYPE RANGE OF sflight-carrid.

TABLES: sflight.

DATA: lt_sflight TYPE STANDARD TABLE OF sflight.

FIELD-SYMBOLS: <fs_sele> TYPE ty_r_carrid.

SELECTION-SCREEN BEGIN OF SCREEN 001.
SELECT-OPTIONS v_sele FOR sflight-carrid NO-EXTENSION NO INTERVALS.
SELECTION-SCREEN END OF SCREEN 001.

SELECTION-SCREEN BEGIN OF SCREEN 002.
SELECT-OPTIONS v_sele1 FOR sflight-carrid.
SELECTION-SCREEN END OF SCREEN 002.

INITIALIZATION.
  IF sy-tcode = 'Z_A'.
    CALL SCREEN 001.
    ASSIGN v_sele[] TO <fs_sele>.
  ELSE.
    CALL SCREEN 002.
    ASSIGN v_sele1[] TO <fs_sele>.
  ENDIF.

START-OF-SELECTION.
  SELECT * FROM sflight INTO TABLE lt_sflight WHERE carrid IN <fs_sele>.

Regards,

Re: sELECT-OPTIONS TROUBLE

former_member156446 — Fri, 25 Apr 2008 18:50:29 GMT

u can use a system variable sy-TCODE

if sy-TCODE = z_a.

select-option...

elseif sy-TCODE = z_b.

select-options...

endif.

Re: sELECT-OPTIONS TROUBLE

Former Member — Fri, 25 Apr 2008 21:27:54 GMT

Check the below code...

RANGES : r_date FOR sy-datum.

DATA : l_id(3).

SELECT-OPTIONS : p_date1 FOR sy-datum MODIF ID tc1.

SELECT-OPTIONS : p_date2 FOR sy-datum NO INTERVALS

NO-EXTENSION

MODIF ID tc2.

INITIALIZATION.

IF sy-tcode = 'TCODE2'.

l_id = 'TC1'. " To Hide P_DATE1

ELSE.

l_id = 'TC2'. " To hIDE P_DATE2

ENDIF.

AT SELECTION-SCREEN OUTPUT.

If Tcode2 is selected date1 will be invisible else date2

LOOP AT SCREEN.

IF screen-group1 EQ l_id.

screen-input = 0.

screen-invisible = 1.

MODIFY SCREEN.

ENDIF.

ENDLOOP.

START-OF-SELECTION.

IF l_id = 'TC1'. " Tcode 2 selected

r_date[] = p_date2[]. " populate date2

ELSE.

r_date[] = p_date1[]. " populate date 1

ENDIF.

use R_DATE in the program <REMOVED BY MODERATOR>

Edited by: Alvaro Tejada Galindo on Apr 25, 2008 5:58 PM

Re: sELECT-OPTIONS TROUBLE

Former Member — Fri, 25 Apr 2008 22:25:27 GMT

Use No Intervals key word after select options field that is it.