topic Re: BDC scrolling problem in Application Development and Automation Discussions

BDC scrolling problem

Former Member — Tue, 11 Oct 2005 16:56:48 GMT

HI ,

I am facing problem while recording for Txn PO13.

I have to enter an infotype by scrolling but not possible.

Any ideas ??

Thanks,

Sandip.

Re: BDC scrolling problem

guillaume-hrc — Tue, 11 Oct 2005 18:15:21 GMT

Is this using a Table Control ?

Are you sure you cannot access it through an index ?

(Which leaves the problem of finding the index by the way...)

Re: BDC scrolling problem

Former Member — Tue, 11 Oct 2005 18:23:00 GMT

I don't think this transaction is a good candidate for BDC. Have you explored other possibilities like a fuction module or a BAPI or a standard SAp program?

Srinivas

Re: BDC scrolling problem

RichHeilman — Tue, 11 Oct 2005 18:27:12 GMT

It is a table control, but there is no "position to" or anything like that which would allow you to go to a certain infotype.

Regards,

Rich Heilman

Re: BDC scrolling problem

Washington — Tue, 11 Oct 2005 19:05:45 GMT

Hi Sandip,

i don't know if it will work in a BDC session, but i tried online and it works, clique in the table control, write P+ in the command and press ENTER.

Re: BDC scrolling problem

Former Member — Wed, 12 Oct 2005 09:24:19 GMT

Hi Washington,

P+ does not work.I used Txn PP02 instead of PO13.

Thanks,

Sandip.

Ph: +44 121 683 2814.

Re: BDC scrolling problem

guillaume-hrc — Wed, 12 Oct 2005 09:32:23 GMT

When I meant 'index', I wanted to say like this :

SAPMH5A0 5100

=> MARKFELD(<b>01</b>) = X

Is not this possible ?

Re: BDC scrolling problem

Former Member — Wed, 12 Oct 2005 15:45:04 GMT

I have tried this one also,but ultimately I have to opt for another transaction.

Thanks anyway.