topic Re: message types in Application Development and Automation Discussions

message types

Former Member — Tue, 18 Mar 2008 09:35:21 GMT

while executing my program in back ground,the status is shown as cancelled and when i checked the job log it gives me an error saying message type unknown.

the statement used in the program is given below

MESSAGE ID SY-MSGID TYPE SY-MSGTY NUMBER SY-MSGNO WITH SY-MSGV1 SY-MSGV2 SY-MSGV3 SY-MSGV4.

rewards will be given for helpful answers

plzzz help me as early as possible....it is very urgent

regards

ranjith

Re: message types

dhruv_shah3 — Tue, 18 Mar 2008 09:39:27 GMT

Hi,

This statement is the syntax for declaring the messages in the Program so pl check it in the program.

Regards,

Dhruv Shah

Re: message types

Former Member — Tue, 18 Mar 2008 09:50:12 GMT

When u run such program in foreground..that goes to dump giving a message that message type ' ' is not found.

So U can run the program by commenting those two lines of code in between if sy-subrc NE 0 and endif.

Thanks

Anon

Re: message types

Former Member — Tue, 18 Mar 2008 09:57:43 GMT

sorry friends i dint get the right answer plz help me ..it s very urgent.......

the program is already written......am just debugging....i had no rights to comment it............

plz help

rewards will be given for helpful answers

regards

ranjith