topic multiple selection in Search Help in Application Development and Automation Discussions

multiple selection in Search Help

Former Member — Tue, 12 Feb 2008 16:45:56 GMT

Hi all,

I have the following requirements:

After press F4, it shows a list of entries from a table. It should allow the user to make a multiple selection. A value is generated based on the selection using some logic and then transports the value to the field.

Any idea?

Thanks in advance!

Regards,

Hui

Re: multiple selection in Search Help

former_member194669 — Tue, 12 Feb 2008 16:53:33 GMT

Hi,

You can find lot of thread in this for forum for your query.

example

a®

Re: multiple selection in Search Help

Former Member — Tue, 12 Feb 2008 16:55:12 GMT

good

pls try this.

Alternatively you may have a look at my sample report ZUS_SDN_F4IF_INT_TAB_VAL_REQ in thread

F4IF_INT_TABLE_VALUE_REQUEST Functionality

thanks

mrutyun^

Re: multiple selection in Search Help

Former Member — Tue, 12 Feb 2008 17:00:12 GMT

Hi,
You can find lot of thread in this for forum for your query.
example
a®s

Thanks ! it's helpful! But my requirement is a little bit different. (Sorry I didn't make it clear)

I created a table maintenance (SM30) for a table. The F4 Search help should be applied to a field of the table when a user creates a new entry. I hope it makes clear.

btw: I have awarded some points! Because it's also good to know some other ways:)

Re: multiple selection in Search Help

former_member194669 — Tue, 12 Feb 2008 17:09:51 GMT

I have a question.

For example: the following is the table maintenance you have


--------------------------------------------
Field1  |  Field2   |  Field3   |   Field4  |
XXX     |  XXX      |  XXX      |   XXX     |   
XXX     |  XXX      |  XXX      |   XXX     |   
XXX     |  XXX      |  XXX      |   XXX     |   
XXX     |  XXX      |  XXX      |   XXX     |   
--------------------------------------------
              ^
              |
              |

If in the above example if you are applying a F4 help for field

Field2 , how will you apply multiple values for field in a row?

a®

Re: multiple selection in Search Help

Former Member — Wed, 13 Feb 2008 14:23:39 GMT

Set CALLCONTROL-MULTISEL = 'x' in Search Help Exit