topic Re: EPC check in Application Development and Automation Discussions

EPC check

Former Member — Thu, 21 Feb 2008 09:23:45 GMT

Hi,

I am getting following warning after EPC

'Field V_BOMUSAGE is not referenced statically in the program'

Please explain how to eliminate it.

Thanks,

Rabiya.

Re: EPC check

Former Member — Thu, 21 Feb 2008 09:27:31 GMT

the error means that the 'Field V_BOMUSAGE is not used anywhere in the program

Delete the declaration of that field

Re: EPC check

Former Member — Thu, 21 Feb 2008 09:28:20 GMT

if u declare a feild in a program and dont use it anywhere it gives this error in epc.

Re: EPC check

Former Member — Thu, 21 Feb 2008 09:30:05 GMT

that means that the Field V_BOMUSAGE is not being used anywhere in the program, so it is ok to remove it. Unless it is being access dynamically. Ii don't think this is a hard error, so you can probably ignore it.

Regs

Edited by: Tushar Mundlik on Feb 21, 2008 10:30 AM

Re: EPC check

Former Member — Thu, 21 Feb 2008 09:37:45 GMT

If you declare any variables and not used then it will show that error message in EPC so please remove un wanted and un used variables

SAP recomonds don't use un nessary variables in the program

Re: EPC check

Former Member — Thu, 21 Feb 2008 09:43:35 GMT

Hi,

whenever a variable is declared, some memory is allocated for the variable.

if there are any unsed variables, its an memory overhead.

EPC will throw an error stating the un-used variables.

regards,

teja.

Re: EPC check

Former Member — Thu, 21 Feb 2008 09:46:27 GMT

Hi,

You will get the corresponding,if you delcared the variable,but not used anywhere in the pgm.

So you can comment that declaration of the variable.