topic Re: Help in dialog programming command in Application Development and Automation Discussions

Help in dialog programming command

Former Member — Wed, 13 Feb 2008 16:45:29 GMT

Hello All:

I am new to dialog programming and I have a code

FIELD ZFIGL_CLOSE_SCHD-SZHKZG MODULE chk_szhkzg on REQUEST.

When the cursor in in field ZFIGL_CLOSE_SCHD-SZHKZG and I hit enter it should validate based on code in chk_szhkzg. First time when screen comes up, when the cursor is in field and I hit enter it does not go through validattion! When I enter something then it goes to validation. I want it to go through validation even if I don't enter anything (I am checking if the fields is blank). Any ideas how to do this?

Thanks.

Mithun

Re: Help in dialog programming command

RichHeilman — Wed, 13 Feb 2008 16:47:21 GMT

Remove the "on REQUEST" part.

Regards,

Rich Heilman

Re: Help in dialog programming command

Former Member — Wed, 13 Feb 2008 16:52:35 GMT

Thanks Rich. I already tried that. Here is the sequence I have

FIELD C_SREF MODULE chk_ref on REQUEST.

FIELD C_SASSIGN MODULE chk_assign on REQUEST.

FIELD ZFIGL_CLOSE_SCHD-SKOSTL MODULE chk_kostl on REQUEST.

FIELD ZFIGL_CLOSE_SCHD-SHKONT MODULE chk_shkont on REQUEST.

FIELD ZFIGL_CLOSE_SCHD-SZHKZG MODULE chk_szhkzg." on REQUEST.

FIELD C_SRATE MODULE chk_srate on REQUEST.

FIELD C_SWRBTR MODULE chk_SWRBTR on REQUEST.

If I remove on request for FIELD ZFIGL_CLOSE_SCHD-SZHKZG and when I enter value for C_SREF and hit enter, it goes directly into valiation for FIELD ZFIGL_CLOSE_SCHD-SZHKZG instead of moving cursor to field C_SASSIGN !

Thanks.

Mithun

Re: Help in dialog programming command

RichHeilman — Wed, 13 Feb 2008 16:56:08 GMT

Do you want to do validation for ALL those fields? If so, remove the ON REQUEST for all those lines of code.

Regards,

Rich Heilman