topic Re: Medruck Problem! in Application Development and Automation Discussions

Medruck Problem!

Former Member — Tue, 22 Jan 2008 12:27:16 GMT

"ITEM TEXT IS NOT PRINTED ON THE PURCHASE ORDER PRINT"

Well, the problem is when i use 45000000 series i get the item text of the po in the print but when i use any 470000000 series po number i don't get item text in the output.

As per the guidance i have gone through the document types i.e NB for 45* series po's and ZDC

( Domestic Capital Eqp ) for 47* series , i culdn't get more info in this regard.

I have debugged the medruck to see that in 45* series po's , after the line item display the controls transfers to element 'item_text' and then to element totals and so on but in 47* series po's the control transfers directly to totals after line item without switching to item_text,

even in the medruck pprogram i can see the only major condition for document type is , if ekko-bsart ne ZC then process the output ( i.e. item text n header text n .. so on)

i couldn't make up why is this element "item_text" not being executed in 47* series, iam sure its only regards to document type but where to alter in medruck is the question.

Thanks in advance

Regards,

Parwez.

Re: Medruck Problem!

daniel_carvalho — Tue, 22 Jan 2008 12:35:19 GMT

Hello,

Have you checked into SPRO transaction the Output Type?

Follow this path:

Materials Management -> Purchasing -> Messages -> Output Control -> Message Types -> Define Message Types for Purchase Order

Check Output Type against Processing Routines and see if you can get any clue.

I hope I helped you.

Daniel.

Re: Medruck Problem!

Former Member — Tue, 22 Jan 2008 12:38:11 GMT

Hi no need to change in MEDRUCK..

you have to change in one of the Standard include.. starts with LMEDRUCKF*..

In debugging mode check on which condition it is not calling the Element ITEM_TEXT. This part of code u will find one of the include starts with LMEDRUCKF. (Observe it in Debug mode)

Change that condition..

Hope it helps.... !!

Regards,

Sai Ramesh

Re: Medruck Problem!

Former Member — Tue, 22 Jan 2008 13:56:02 GMT

Hi!

Actually the control after processing the Data Element 'line item' it is directly going to Data Element 'Total' and item_text element is in between the above two elements and as fara as condition is concerned the condition is starting inside the data element item_text, so if control doesn't even passes thru this element then it can't check for condition even.

Regrads,

Parwez.

Awaiting reply