topic Re: Newbie. Function module. default value not working. in Application Development and Automation Discussions

Newbie. Function module. default value not working.

Former Member — Fri, 25 Jan 2008 14:21:38 GMT

Hi,

i have created a function module for a simple program with two numbers and operator as parameters and will give result based on the operators '+', '-', '*', '/'.

In the function module builder, i have created a field for the operator as fp_opr and given the default value as '+'. when i called this function from the program by giving operator , -,/ , it is working fine. but if i don't give any parameter, it is returning 0 value. since i have given the operator's default value in function module as '', i am expecting addition. but it is returning 0.

please help. What I am doing wrong?

thanks in advance.

Re: Newbie. Function module. default value not working.

Former Member — Fri, 25 Jan 2008 15:01:07 GMT

Hello,

You have to enter 'default value' for the operator in the import tab of SE37. It should work.

Thanks,

Venu

Re: Newbie. Function module. default value not working.

Former Member — Sat, 26 Jan 2008 14:45:03 GMT

Hi,

I have given the '' operator as default in function module itself. when i run the program in function module, then the operator is '' by default and working fine. when i call this function from program, i am expecting the samething. but '+' is not popping as default and i need to give the operator everytime.

Is it supposed to work in function module only? Any ideas on this please?

Thank you.

Re: Newbie. Function module. default value not working.

former_member156446 — Sat, 26 Jan 2008 20:42:25 GMT

HI Neeraja

The default value works, good when you want to test the FM in se37 only. You cannot have that default value shown when you call that FM in the program. thats not possible.

Regards

JJ.

Re: Newbie. Function module. default value not working.

Former Member — Sun, 27 Jan 2008 12:06:22 GMT

Thank you.