topic select option in Application Development and Automation Discussions

select option

Former Member — Mon, 07 Jan 2008 04:46:44 GMT

hi,

How to make a to-field mandatory in a select-options. This is my select-option.

select-options:

s_rpmax for zupi5t-rpmax obligatory no-extension. "Period

This is an obligatory field. If i try to execute the program without giving any data then this will rise an error message (because its an obligatory field right).

But the requirement is when i execute the program by giving data in the from-field and not giving the data in to-field of select-option then also the error message should rise.

Is there any way to do that if so please help me out.

Thanks & Regards

Ramya.

Re: select option

former_member156446 — Mon, 07 Jan 2008 04:49:11 GMT

then remove the obligatory and code it in ur program

saying

if s_rpmax-low is initial.

message I

end if.

if s_rpmax-high is initial.

message I

endif.

Re: select option

kesavadas_thekkillath — Mon, 07 Jan 2008 04:49:19 GMT

select-options:

s_rpmax for zupi5t-rpmax no-extension. "Period

at selection-screen on s_rpmax.

if s_rpmax-low is initial or s_rpmax-high is initial.

throw error.

endif.

Re: select option

Former Member — Mon, 07 Jan 2008 04:50:13 GMT

Hi,

Remove no extension and try

Regards

Re: select option

Former Member — Mon, 07 Jan 2008 04:53:57 GMT

Hi Ramya,

Obligatory in Select-Options is used to check only the Lower Range.

I would suggest a solution to check upper range also.

Take 2 obligatory parameters where first parameter represents lower range(From) and second parameter represents higher range(to).

Then take a range variable and assign these values to this range and use this range variable in ur selection.

awrd points if helpful

Bhupal

Re: select option

Former Member — Mon, 07 Jan 2008 05:14:02 GMT

SELECT-OPTIONS : s_rpmax for zupi5t-rpmax obligatory.

***

AT SELECTION-SCREEN.

if s_rpmax-low is initial.

MESSAGE e184(sabapdocu) WITH 'The second field is found empty'.

endif.

Re: select option

Former Member — Mon, 07 Jan 2008 10:02:17 GMT

Hi try this,

After ur select statment go for the below message.

s_rpmax for zupi5t-rpmax obligatory .

if s_rpmax-high = ' '.

message e000(00) with 'enter to value'.

endif.

Re: select option

Former Member — Mon, 07 Jan 2008 10:08:08 GMT

Hi Ramya,

Try this.

select-options: s_rpmax for zupi5t-rpmax obligatory no-extension.

AT SELECTION-SCREEN OUTPUT.

loop at screen.

if screen-name eq 'S_RPMAX-HIGH'.

screen-required = 1.

modify screen.

endif.

endloop.

Rewards points if helpful.

Regards,

Srinivas Ch