topic Re: debug not going to break point in Application Development and Automation Discussions

debug not going to break point

Former Member — Mon, 07 Jan 2008 22:26:21 GMT

Hi All,

I am trying to debug a print program for sapscript. I have set up break points in both the DEV and QAS environment in the same print program. But when I run the sapscript form, it is not going to the break point in DEV but debugging fine in QAS for the same program.

Could you assist on what could be the reason, it is not going to break point in DEV. Thanks.

Regards,

Re: debug not going to break point

Former Member — Mon, 07 Jan 2008 22:30:15 GMT

Under Utilities try to "update the navigation index" for the program and then set the break point again.

Also check if the number of debug sessions assigned are more than currently being used in the DEV system. (ask basis for help)

-Cheers

Re: debug not going to break point

Former Member — Tue, 08 Jan 2008 04:14:31 GMT

Hi Fs,

The problem may be we cannot activate ur Print program check it once.If the print program is not in active we cannot put BREAK POINT.

Award points if helpful.

Kiran Kumar.G

Have a Nice Day..

Re: debug not going to break point

Former Member — Tue, 08 Jan 2008 04:21:11 GMT

I dont know but it may work

go to System-> utilities->debug abap

i tried this with BSP

Check if it helps you

Re: debug not going to break point

former_member219399 — Tue, 08 Jan 2008 04:34:45 GMT

Hi,

Check if this breakpoint is within a condition, like if..endif. also check whether this condition is satisfying.

if its within a subroutine, put a break point at the call of subroutine, ie. at perform statement.

With regards,

Vamsi