topic call transaction in Application Development and Automation Discussions

call transaction

Former Member — Fri, 21 Dec 2007 16:18:29 GMT

I encounter problem when passing values from program A to program B. In program B, there is a field with a parameter ID tied to it. I have written something like this:

SET PARAMETER ID <PID> <VALUES FROM PROGRAM A>.

CALL TRANSACTION <PROGRAM B'S TCODE>.

When I execute, there is no values being passed into program B. I have tested the above codes by calling standard transaction codes and was able to get values on the standard tcode screen. Would anyone know why when I pass to a customized program, it did not have the value in it? Is there any extra steps that needs to be done?

Please advice.Thanks

Re: call transaction

RoySayak — Fri, 21 Dec 2007 16:23:12 GMT

u must use GET PARAMETER-ID in program B. i think u've missed that.

Reward if useful

Thanks

Sayak

Re: call transaction

Former Member — Fri, 21 Dec 2007 16:29:23 GMT

You can only use that method to pass values to a transaction not to a Program.

If you want to pass values to another program then use the statement SUBMIT. Keep a break-point at this statement. On clicking F5 you can see the flow from Program A to Program B.

If you want to return to program A then use the Return Addition.

Re: call transaction

Former Member — Fri, 21 Dec 2007 16:29:34 GMT

This is an exemple:

Program A:

SET PARAMETER ID: 'NUM' FIELD tg_zmmagrcol1-zagrnum,

'RB1' FIELD c_x.

CALL TRANSACTION c_trans AND SKIP FIRST SCREEN.

Program B:

MODULE status_0100 OUTPUT.

SET PF-STATUS 'MENU_0100'.

IF NOT sy-calld IS INITIAL.

GET PARAMETER ID: 'NUM' FIELD vg_zagrnum_low,

'RB1' FIELD rb1.

ENDIF.

Hope it helps.

Chang