topic Re: Hyperlink in Table Control in Application Development and Automation Discussions

Hyperlink in Table Control

Former Member — Tue, 11 Dec 2007 18:12:58 GMT

Hi Everyone,

I am currently working on a module pool program where one of the requirements is to have hyperlink on the values in one of the columns in a table control. As far as I know it is not possible, I have already done my research and also searched this forum for any earlier posts regarding this but couldn't get any.

Is this possible and if so how do I go about it? I have already mentioned to the client that it might not possible but wanted to be sure before confirming to them and suggesting an alternate solution.

Thanks in Advance.

Kalyan.

Re: Hyperlink in Table Control

former_member196299 — Wed, 12 Dec 2007 04:25:40 GMT

HI Kalyan ,

I am not sure whether it is possible to have a hyperlink in the Modulepool program , as the hyperlink is to connect to open a link online . But yes this is verymuch possible in Webdynpro which is internet accessible .

Well I'll try getting some confirmed response from my colleagues ...

Regards,

Ranjita

Re: Hyperlink in Table Control

Former Member — Wed, 12 Dec 2007 07:34:36 GMT

You would probably have to have a column in the table control that is defined as a "pushbutton" to give you a "single click" option to leap off to a URL.

Jonathan

Re: Hyperlink in Table Control

Former Member — Wed, 12 Dec 2007 22:49:38 GMT

Hi Ranjita,

Thanks for your reply, yes even I feel it's not possible. But please let me know in case you get any leads.

Again, thanks!!

Kalyan.

Re: Hyperlink in Table Control

Former Member — Wed, 12 Dec 2007 22:50:22 GMT

Hi Jonathan,

That's a good suggestion, I will try it out. Thanks!!

Kalyan.

Re: Hyperlink in Table Control

Former Member — Wed, 12 Dec 2007 23:02:24 GMT

Thanks Jonathan...It worked