topic Re: Interactive Report in Application Development and Automation Discussions

Interactive Report

Former Member — Tue, 20 Nov 2007 10:13:12 GMT

Dear All ,

I am writting the given below code .

tables MARC .

DATA T_MARA LIKE TABLE OF MARA WITH HEADER LINE .

SELECT * FROM MARA INTO TABLE T_MARA UP TO 20 ROWS .

END-OF-SELECTION .

LOOP AT T_MARA.

WRITE : / T_MARA-MATNR , T_MARA-MBRSH .

HIDE T_MARA-MATNR .

ENDLOOP .

AT LINE-SELECTION.

if sy-lsind = 1 .

select * from marc where matnr = T_MARA-MATNR .

WRITE : MARC-MATNR , MARC-WERKS .

ENDSELECT .

ENDIF .

This code works fine and also responds to At line-selection event . Now if I add SET PF-STATUS 'ZSTATUS' immediately after END-OF-SELECTION. then my program do not navigate to detail list . what is the problem .

Re: Interactive Report

Former Member — Tue, 20 Nov 2007 10:17:54 GMT

AFTER THE END-OF-SELECTION THE DETAIL LIST CAN'T BE DISPLAYED

IF YOU WANT TO DISPLAY SECONDARY LIST THEN DON'T USE END-OF-SELECTION BECAUSE AFTER BASIC LIST GENARATED THE END-OF-SELECTION EVENT WILL TRIGGER WHICH IT WILL DISCONNECT THE CONNECTION TO THE DATBASE

SO IF YOU WANT TO DISPLAY SOME DETAILED LIST THEN DON'T USE END-OF-SELECTION EVENT

USE ONLY FOR THE CLASSICAL REPORT

REWARD IF USEFUL

Re: Interactive Report

Former Member — Tue, 20 Nov 2007 10:19:06 GMT

THATS WHY END-OF-SELECTION IS USED MAINLY IN LDB REPORTS

Re: Interactive Report

Former Member — Tue, 20 Nov 2007 10:23:49 GMT

Your problem is..

At a time you can't use AT LINE SELECTION & AT USER COMMAND unless you do following..

in SE41 open ZSTATUS in change mode.

in front of Funtion key 'F2' replace <..> with PICK ..save and activate

then it works...

Re: Interactive Report

Former Member — Tue, 20 Nov 2007 10:26:38 GMT

HI,

I think u got a error chooes a valid function. ok first u double click the pf ststus name and open the function keys F2 function is there in Recommended function key settings now there Choose option is there u may delete and give pick it will be work.

Re: Interactive Report

Former Member — Tue, 20 Nov 2007 10:35:46 GMT

Hi Raghavendra,

SET PF-STATUS IS ONLY USED FOR AT USER-COMMAND.

IT DOESNT WORK FOR LINE SELECTION.

IF WE WANT TO USE SET PF-STATUS IT CAN ONLY ACTICATE BACK,EXIT,CANCEL BUTTONS ONLY.

IT DOESNT GO FOR INTERACTION..

IF U R SATISFY WITH THIS ANSWER GIVE ME REWARD POINTS FOR ME

I AM SURE ABOUT WITH MY ANSWER