topic Cursor possition in table control in Application Development and Automation Discussions

Cursor possition in table control

Former Member — Fri, 23 Nov 2007 08:43:13 GMT

Hi all,

Is there any way to get cursor position in table control.Suppose if am in fourth or fifth column in table control when i presses enter from there it should add all the data's in the particular column then i will have textbox outside the table control so that i can display the results in that textbox.if any other easier way than this kindly suggest me.

Re: Cursor possition in table control

former_member386202 — Fri, 23 Nov 2007 08:47:16 GMT

Hi,

Use set cursor field.

Regards,

Prashant

Re: Cursor possition in table control

Former Member — Fri, 23 Nov 2007 08:47:24 GMT

Table Controls in ABAP Programs

Cursor Position on Table Controls

At PBO you can set the cursor on a specific field of a specific row of a table control.

SET CURSOR FIELD .

if you only want to determine the row of the table control. SY´-SUBRC allows you to check if the cursor is placed in a row of a table control.

Re: Cursor possition in table control

Former Member — Fri, 23 Nov 2007 09:53:18 GMT

try this

GET CURSOR LINE SY-STEPL.

READ TABLE ITAB INDEX SY-STEPL.

thn do the assignment where everu want to show the data

txtbox = itab-empname

txtbox1 = itab-empno

.........

rgds,

Sunny