topic select-options value in Application Development and Automation Discussions

select-options value

Former Member — Mon, 19 Nov 2007 13:19:51 GMT

Hi all.

I have defined a select-options with no intervals. I want to loop through all the values that are input in select-options. Can i use loop at or do i need to fetch the vaues in an itab first?

thanks,

Re: select-options value

Former Member — Mon, 19 Nov 2007 13:21:16 GMT

Hi,

You can do loop on select-options field.

Regards,

Satish

Re: select-options value

Former Member — Mon, 19 Nov 2007 13:26:54 GMT

HI Hitesh,

A sample example for looping at selct-options.

tables MARA.

select-option : mat for mara-matnr.

DATA: BEGIN OF ITAB OCCURS 0,

MATNR TYPE MARA-MATNR,

END OF ITAB.

START-OF-SELECTION.

LOOP AT MAT.

MOVE MAT-LOW TO ITAB-MANTR.

APPEND ITAB.

ENDLOOP.

Please reward if usefull.

Thanks,

Gokul.

Re: select-options value

Former Member — Mon, 19 Nov 2007 13:29:24 GMT

HI,

yes you can do <i>loop at</i>.

rgs

Re: select-options value

Former Member — Mon, 19 Nov 2007 13:37:28 GMT

YOU CAN PUT LOOP AT SELECT-OPTIONS

NO PROBLEM AT ALL

Re: select-options value

Former Member — Mon, 19 Nov 2007 13:54:51 GMT

Hi,

Yes you can use it, below is the sample code :

tables : bsis.

data : count type i.

data : begin of itab occurs 0,

buzei like bsis-buzei,

end of itab.

select-OPTIONS : num for bsis-buzei.

start-of-SELECTION.

count = 1.

do num-high times.

if count = 1.

count = num-low.

move : count to itab-buzei.

append itab.

clear itab.

count = count + 1.

else.

move : count to itab-buzei.

append itab.

clear itab.

count = count + 1.

endif.

if count GT num-high.

exit.

ENDIF.

enddo.

Thanks,

Sriram Ponna.

Re: select-options value

Former Member — Mon, 19 Nov 2007 13:57:33 GMT

Hi Hitesh

It may not be a good programming practice to Loop at select-options(it will give you the results).

Get all the relevant entries in an itab from the check table or so then loop.

Regards

Arun