topic Re: Why I can not debug the program in Application Development and Automation Discussions

Why I can not debug the program

Former Member — Fri, 26 Oct 2007 07:29:03 GMT

Hi all,

Even I have set a breakpoint at a statement, it does not fall into this line.

What could be the problem?

Thanks.

varma_narayana — Fri, 26 Oct 2007 07:33:01 GMT

Hi Deniz..

Put the Cursor in the Line. And Set the Break point.

Don't select the Line While setting break point. Then it will set it for the Next statement.

Reward if Helpful.

Former Member — Fri, 26 Oct 2007 07:33:08 GMT

hi deniz

pls check the before statement of break point .

bcz before statement working fine its coming next statement other wise its not come.

pls check before statement .

first u check the /h and break point u analyze easily

regard

kk.

JozsefSzikszai — Fri, 26 Oct 2007 07:35:32 GMT

hi Deniz,

there could various reasons behind...

- your breakpoint is in some conditions (IF, CASE, ...) and the conditions are not fulfilled

- your breakpoint in a system program and that is not debuggable by default (turn on system debugging)

hope this helps

Former Member — Fri, 26 Oct 2007 08:02:45 GMT

May be you set the break point in any IF or CASE conditions inside, which doesn't get the value true...

Or else...if you are using BSP application...instead of using normal breakpoint use External breakpoint (which is valid for 2 hours)...

Or your process may be running in the Background job....

Or Activate your program first and then put the breakpoint....