topic Re: work area or table not referenced statically in the program in Application Development and Automation Discussions

work area or table not referenced statically in the program

Former Member — Thu, 27 Sep 2007 14:27:20 GMT

Hi Friends,

When i make extended syntax check for my program, i am getting error as this work area or table not referenced statically in the program .

How can i overcome that .

Please give solution nfor this .

Thanx.

Title was edited by:

Alvaro Tejada Galindo

Re: work area or table not referenced statically in the program

RichHeilman — Thu, 27 Sep 2007 14:28:58 GMT

I think that means that the workarea of internal table is not being used anywhere in the program, so it is ok to remove it. Unless it is being access dynamically. Ii don't think this is a hard error, so you can probably ignore it.

Regards,

RIch Heilman

Re: work area or table not referenced statically in the program

Former Member — Thu, 27 Sep 2007 14:59:49 GMT

While Rich has already provided you the right solution, I think you are concerned about this error only because of your "Project Standards" - which says no EPC errors.

So delete the work area or field from your data definitions if you think that it is not being used.

If you think it being used dynamically put a comment of " #EC NEEDED next to it. The error will now be hidden.

Regards,

Srihari