topic Re: Debugger help - New Debugger in Application Development and Automation Discussions

Debugger help - New Debugger

Former Member — Fri, 31 Aug 2007 13:33:50 GMT

How do you change the field contents in the new debugger? I have no problem doing it in the old debugger but it is a pain to switch back and forth between them.

I see the pencil to the right of the field contents but the field contents are grayed out so I can't edit them.

Regards,

Davis

Re: Debugger help - New Debugger

Former Member — Fri, 31 Aug 2007 13:43:13 GMT

You can swith to classic debugger if you need

here you can edit values too

Navigation

goto debugging -> debugger -> swith to classic debugger

Within new debugger ->

or click on variable -> double click on pencil -> now you will able to change

Thanks

Seshu

Re: Debugger help - New Debugger

RichHeilman — Fri, 31 Aug 2007 13:45:25 GMT

Once in debugger, double click the variable which you want to change, it will show up on the section to the right. yes the value is greyed out there, but then double -click on the variable name on that side, Now you are at the detail level, if you want to change the value, click the pencil beside the value field, it will be opend, change the value and hit enter. That's it.

Regards,

RIch Heilman

Re: Debugger help - New Debugger

Former Member — Fri, 31 Aug 2007 13:46:06 GMT

Seshu, thanks for the tip but, as I posted, I find that to be a pain. I imagine you can do it in the new debugger, being that there is an icon for it, but I can't figure it out.

Davis

Re: Debugger help - New Debugger

Former Member — Fri, 31 Aug 2007 13:48:33 GMT

Rich,

Thanks for the help! I was only single-clicking on the pencil. I know, I know, when in doubt double-click.

Thanks again,

Davis