topic module pool in Application Development and Automation Discussions

module pool

Former Member — Wed, 31 Aug 2005 05:18:48 GMT

hai frnds,

i am in a situation in which i am making a field invisible using

loop at screen.

if screen-group1 = 'G01'.

screen-invisible = 'X'.

endif.

modify screen.

endloop.

when i am debugging the piece of code written in it is executed correctly but the changes were not reflected at runtime. i am not able to get where the actual problem is lying. plz help this in this regard

Re: module pool

Former Member — Wed, 31 Aug 2005 05:25:08 GMT

where did u write this code ?

instead of 'X' try with '0' or '1'.

regds

Message was edited by: Venkat

Re: module pool

Former Member — Wed, 31 Aug 2005 05:41:31 GMT

Hi,

Write ur code in the PBO of ur screen.

case ok_code.

when 'CHG'.

loop at screen.

if screen-name = 'ZC7_EMPLOYEE-RUTEMPID'.

screen-input = 0.

modify screen.

endif.

endloop.

endcase.

Use the value '0' or "1' instead of 'X' .

Hope it helps u.

Kindly reward point if this helps u.

Thanks&Regards,

Ruthra.R

Re: module pool

Former Member — Wed, 31 Aug 2005 06:03:18 GMT

otherwise you can try

screen-active = 'X'.

modify screen.

regards,

suresh

Re: module pool

Former Member — Wed, 31 Aug 2005 06:46:50 GMT

hi, Ateeq

you should set 1 to screen-invisible, if you want to hide them in the screen.

And please also pay attention to the screen-group1, if no special setting, the field won't belong to any screen-group. In the screen painter, you can set the screen-group in the Attributes windows.

Hope it will be helpful

thanks

Re: module pool

Former Member — Wed, 31 Aug 2005 06:57:38 GMT

Hi,

For making any value visible or invisible the values used are 0 and 1 not 'X'. the loop should run in the PBO before the screen is displayed, for this create a module in the flowlogic and call the loop statement inside it.

What are the controls? I/O or radio buttons? and also tell how are you grouping them using chain...endchain?

Please also check the values in the screen table in debug mode.

Cheers....